НПП Азимут - гироскопические и магнитные инклинометрические системы
 русская версия
НовостиО компанииПродукцияКлиентыКонтакты



 

 

 

 

  

AUTONOMOUS  

GIMBALLESS 

MAGNETOMETRIC 

MULTIPLEPOINT 

CONTINUOUS 

INCLINOMETER

 

 

 

IMMC-73-180/100 

 

 

 

      Autonomous gimballess magnetometric inclinometer (MI) is designed to measure  inclination angle, directional readings, whipstock positioning angle and the vertical depth of deviated and horizontal open wells, may be installed into hardwire telemetric bottom-hole systems as well.

        The advantages of the given MI over similar CIS magnetometric inclinometers are the following:

 MI provides continuous and point inclinometry and their prompt alignment;

 in MI a “control-test” is foreseen, allowing to automatically control tool operation efficiency during the process of work and minimize tests before well descent;

 - the MI is designed as a modular construction, allowing to reduce the volume of maintenance and repair works.   

       The system software allows you to promptly receive intermediary results of the inspection of the vertical depth and the well angle in graphic and numeric form, inspect its every section in detail.   

The full set:    

1.        Well-logging tool with orienting sub.  

2.        Ground operator’s stand.                              

3.         Computer (on the request of the customer). 

4.         Software.                                                          

5.         Uninterruptable power supply.        

  

 Technical properties:

Directional readings measurement range,                   degrees                              0…360

Inclination angle measurement range,                         degrees                              0...180

Directional readings deviation,                                     degrees.                             2 (1)

Inclination angle deviation,                                           degrees                              0,1

Vertical depth of well deviation                                     % from depth                   0,2

Directional readings measurement time in gyroscopic min.                                 0,5 (2)

point mode,                   

Outside diameter of well-logging tool                           mm                                     73

Length of the well-logging tool                                      mm                                    1600

Length of orienting sub                                                   mm                                    2500

The well-logging tool may operate for 1,5 hours with ambient temperature at °С  180

Ground stand operation temperature range                 °С                                       -10…+55

Maximum operating pressure of the well-logging      МPа                                    100

tool

Consumption capacity does not exceed                       W                                       15

Weight of the well-logging tool with orienting sub    kg                                       30

Connection of the well-logging tool with the ground

operator’s stand with the help of a three-core cable

Type of interface with computer                                                                                RS-232C

                                                                       

       The constituents, technical properties, the term and delivery conditions, the price and other terms shall be established by the contract.

 


 

© 2007 R&D enterprise “Azimuth”. All rights reserved